1篇
您的检索式：作者名="Mohsen Samimi"
|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Electro-spray of high viscous liquids for producing mono-sized spherical alginate beads显示文摘Alginate beads, often used for controlled release of enzymes and drugs, are usually produced by spraying sodium alginate liquid into a gelling agent using mechanical vibration nozzle or air jet. In this work an alternative method of electro-spray was employed to form droplets with desired size from a highly viscous sodium alginate solution using constant DC voltage. The droplets were then cured in a calcium chloride solution. The main objective was to produce mono-sized beads from such a highly viscous and non-Newtonian liquid (1000-5000 mPa s). The effects of nozzle diameter, flow rate and concentration of liquid on the size of the beads were investigated. Among the parameters studied, voltage had a pronounced effect on the size of beads as compared to flow rate, nozzle diameter and concentration of alginate liquid. The size of beads was reduced to a minimum value with increasing the voltage in the range of 0-10 kV. At the early stages of voltage increase (i.e. up to about 4 kV), the rate of size reduction was relatively low, while the dripping mode dominated. However, in the middle part of the range of applied voltage, where the rate of size reduction was high (i.e. about 4-7 kV), an unstable transition occurred between dripping and jetting. At the end part of the range (i.e. 7-10 kV) jet mode of spray was observed. Increasing the height of fall of the droplets was found to improve the sphericity of the beads, because of the increased time of flight for the droplets. This was especially identifiable at higher concentrations of the alginate liquid (i.e. 3 w/v%). | Hamid Moghadam Mohsen Samimi Abdolreza Samimi Mohamad Khorram | 2008 | Particuology2008，6，4： | 3 |
您所在的机构暂未开通此部分的功能，请联系管理员