| 1 | THE SULFIDATION/OXIDATION RESISTANCE OF TWO Ni-Cr-Al-Y ALLOYS AT 700℃显示文摘The high temperature corrosion resistance of Ni-25.gCr-13.5Al-1.2Y-0.6Si and Ni-10.2Co-12.4 Cr-16.0A l-0.5 Y-0.2Hf alloys was assessed in sulfidation/oxidation environments.In the environment with a sulfur partial pressure of 1Pa.and an oxygen partial pressure of 10-19Pa,both these alloys exhibited three distinct stages in the weight gain-time curve when tested at 700℃.In the initial stage,selective sulfidation of Cr suppressed the formation of the other metal sulfides,resulting in lower weight gains.In the transient stage,breakdown and cracking of Cr sulfides and insufficient concentration of Cr at the outer zone led to the rapid formation of Ni sulfides and a rapid increase in weight.In the steady-state stage,corrosion was controlled by the diffusion of anions and/or cations,which led to a parabolic rate law. | Y.X.Lu W.X.Chen R-Eadie | 2004 | Acta Metallurgica Sinica(English Letters)2004，17，2： | 2 |
| 2 | HYDROGEN EFFECT ON DEFORMATION BEHMIOR OF TITANIUM ALLOY AT HIGH TEMPERATURE显示文摘The effect of hydrogen on the deformation behavior of three typical kinds of titanium alloys, pure Ti, Ti-6Al-4V and Ti-15V-3Cr-3Al-3Sn (Ti-15-3), at high temperature has been investigated by short time creep test. XRD and TEM techniques are used to examine the changes in their microstructures. The results show that deformation rutes of pure Ti and Ti-6Al-4V alloy can be greatly increased by hydorgen charping due to an increase of β phase volume in their microstructures. β→α transformation is found to occur in unchanged Ti-15-3 alloy during creep process. The addition of 0. 73wt% hydrogen can completely inhibit the deformation-induced transformation and strengthen the metastable β phase in Ti-15-3 alloy, resulting in a dramatic decrease of deformation rate of this alloy at 700° C. | C.H.Zhou K.Yang D.F.Li Y.X.Lu | 1998 | Acta Metallurgica Sinica(English Letters)1998，11，3： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员