| 1 | Microstructure and tensile properties of DD32 single crystal Ni-base superalloy repaired by laser metal forming显示文摘In this work,the microstructure and tensile properties of DD32 single-crystal(SC)superalloy repaired by laser metal forming(LMF)using pulsed laser have been studied in detail.The microstructures of the deposited samples and the tensile-ruptured samples were characterized by optical microscopy(OM),transmission electron microscope(TEM)and scanning electron microscope(SEM).Due to high cooling rate,the primary dendrite spacing in the deposited area(17.2μm)was apparently smaller than that in the substrate area(307μm),and the carbides in the deposited samples were also smaller compared with that in the substrate area.The formation of(γ+γ’)eutectic in the initial layer of repaired SC was inhibited because of the high cooling rate.As the deposition proceeded,the cooling rate decreased,and the(γ+γ’)eutectic increased gradually.The(γ+γ’)eutectic at heat-affected zone(HAZ)in the molten pool dissolved partly because of the high temperature at HAZ,but there were still residual eutectics.Tensile test results showed that tensile behavior of repaired SC at different temperatures was closely related to the MC carbides,solidification porosity,γ’phase,and(γ+γ’)eutectic.At moderate temperature,the samples tested fractured preferentially at the substrate area due to the fragmentation of the coarse MC carbide in the substrate area.At elevated temperature,the(γ+γ’)eutectic and solidification porosity in the deposited area became the source of cracks,which deteriorated the high-temperature properties and made the samples rupture at the deposited area preferentially. | Shiwei Ci Jingjing Liang Jinguo Li Yizhou Zhou Xiaofeng Sun | 2020 | Journal of Materials Science & Technology2020，42，10： | 6 |
| 2 | Prediction of Primary Dendrite Arm Spacing in Pulsed Laser Surface Melted Single Crystal Superalloy显示文摘Primary dendritic arm spacing(PDAS)is an important microstructure feature of the nickel-base single crystal superalloys.In this paper,a numerical model predicting the PDAS evolution with additive manufacturing parameters using pulsed laser is established,which combines the theoretical PDAS models with the temperature field calculation model during pulsed laser process.Based on this model,processing maps that related process parameters to the evolution of PDAS are generated.To obtain more accurate prediction model,the parameters of different solidification conditions,G^(-0.5)V^(-0.25) and G^(-0.5)V^(-0.25),are selected to calculate PDAS.The simulation results show that the PDAS increases as the arise of P and t.The processmgPDAS map can accurately predict the evolution of PDAS with pulsed laser process parameters,which is well in accordance with the experimental results.Additionally,the PDAS values calculated by the G^(-0.5)V^(-0.25) are more in line with the experimental results than those calculated by the G^(-0.5)V^(-0.25). | Shiwei Ci Jingjing Liang Jinguo Li Haiwei Wang Yizhou Zhou Xiaofeng Sun Hongwei Zhang Yutian Ding Xin Zhou | 2021 | Acta Metallurgica Sinica(English Letters)2021，34，4： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员