|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Droplet characteristics in the multi-staged high speed disperser with single inlet显示文摘Droplet characteristics in the cavity zone of a multi-staged high speed disperser with single inlet were studied in this paper. The influences of both the operating and structural parameters on the mean droplet diameter, size distribution and liquid flux distribution were quantitatively analyzed. The result showed that the mean droplet diameter decreased with the increase of rotational speed and the number of rotors;whilst there is little influence on the inlet flow rate. In the experimental range, the minimum value of mean droplet diameter is 0.57 mm, 0.48 mm, 0.41 mm in the two-staged, three-staged and four-staged rotors, respectively. The Rosin–Rammler(R–R) distribution could describe the droplet size distribution appropriately, and it became uniform with the increase of rotational speed and the number of rotor, while the inlet flow rate had little effect on the droplet size distribution. The liquid flux distribution curves were always unimodal. With the increase of rotational speed, the location of maximum liquid flux ratio moved from zone 3 to zone 4 and this value decreased from 22.1% to 18.1%. Using Coefficient of Variation(CV) to indicate the uniformity of liquid flux distribution, it was found that the CV decreases from 47.5% to 22.7%when the number of rotor increased from 2 to 4. | Ao Nie Ziqi Cai Zhengming Gao Zhimiao Wang Archie Eaglesham | 2019 | Chinese Journal of Chemical Engineering2019，27，8： | 0 |
| 2 | Research on the generation method of seawater sound velocity model based on Perlin noise显示文摘In the processing of conventional marine seismic data,seawater is often assumed to have a constant velocity model.However,due to static pressure,temperature difference and other factors,random disturbances may often frequently in seawater bodies.The impact of such disturbances on data processing results is a topic of theoretical research.Since seawater sound velocity is a difficult physical quantity to measure,there is a need for a method that can generate models conforming to seawater characteristics.This article will combine the Munk model and Perlin noise to propose a two-dimensional dynamic seawater sound velocity model generation method,a method that can generate a dynamic,continuous,random seawater sound velocity model with some regularity at large scales.Moreover,the paper discusses the influence of the inhomogeneity characteristics of seawater on wave field propagation and imaging.The results show that the seawater sound velocity model with random disturbance will have a significant influence on the wave field simulation and imaging results. | Zhimiao Chang Fuxing Han Zhangqing Sun Zhenghui Gao Xueqiu Wang | 2024 | Acta Oceanologica Sinica2024，43，1： | 0 |
| 3 | On the improvement of power conversion efficiency of parametric arrays显示文摘Due to the low power conversion efficiency of parametric array, the proposed method can be used to improve the power conversion efficiencies of parametric arrays by adjusting the specific acoustic impedance. The Kuznetsov equation that describes parametric arrays is first studied, the inffuence of Lagrangian densities on difference frequency wave is analyzed,and the relationship between the Lagrangian density and the acoustic impedance is obtained.Subsequently, the method of arranging perforated plates around the parametric array to adjust the acoustic impedance is proposed. The proposed method is validated through numerical simulations. The results show that this method can improve the power conversion efficiency of the parametric array by using perforated plates to change the acoustic impedance. | LU Zhimiao MENG Jin WANG Bo ZHAO Zhihua HU Anqi | 2023 | Chinese Journal of Acoustics2023，42，4： | 0 |
| 4 | High catalytic performance of CuCe/Ti for CO oxidation and the role of TiO_(2)显示文摘CuCe/Ti-A and CuCe/Ti-R catalysts were prepared using anatase TiO_(2)(TiO_(2)-A)and rutile TiO_(2)(TiO_(2)-R)as supports using the incipient wetness impregnation method for the carbon monoxide(CO)oxidation reaction and were compared with a CuCe-C catalyst prepared using the co-precipitation method.The CuCe/Ti-A catalyst exhibited the highest activity,with complete CO conversion at 90℃,when the gas hourly space velocity was 24000 ml.g^(-1).h^(-1) and the CO concentration was approximately 1%(vol).A series of characterizations of the catalysts revealed that the CuCe/Ti-A catalyst has a larger specific surface area,more Cu+species and oxygen vacancies,and the Cu species of CuCe/Ti-A catalyst is more readily reduced.In situ FT-IR results indicate that the bicarbonate species generated on the CuCe/Ti-A catalyst have lower thermal stability than the carbonate species on CuCe/Ti-R,and will decompose more readily to form CO_(2).Therefore,CuCe/Ti-A has excellent catalytic activity for CO oxidation. | Tingting Chang Ziyan Wang Zhimiao Wang Hualiang An Fang Li Wei Xue Yanji Wang | 2023 | Chinese Journal of Chemical Engineering2023，62，10： | 0 |
| 5 | Three-dimensional dynamic sea surface modeling based on ocean wave spectrum显示文摘In conventional marine seismic exploration data processing,the sea surface is usually treated as a horizontal free boundary.However,the sea surface is affected by wind and waves and there often exists dynamic small-range fluctuations.These dynamic fluctuations will change the energy propagation path and affect the final imaging results.In theoretical research,different sea surface conditions need to be described,so it is necessary to study the modeling method of dynamic undulating sea surface.Starting from the commonly used sea surface mathematical simulation methods,this paper mainly studies the realization process of simple harmonic wave and Gerstner wave sea surface simulation methods based on ocean wave spectrum,and compares their advantages and disadvantages.Aiming at the shortcomings of the simple harmonic method and Gerstner method in calculational speed and sea surface simulation effect,a method based on wave equation and using dynamic boundary conditions for sea surface simulation is proposed.The calculational speed of this method is much faster than the commonly used simple harmonic method and Gerstner wave method.In addition,this paper also compares the new method with the more commonly used higher-order spectral methods to show the characteristics of the improved wave equation method. | Zhimiao Chang Fuxing Han Zhangqing Sun Zhenghui Gao Lili Wang | 2021 | Acta Oceanologica Sinica2021，40，10： | 0 |
| 6 | Enhanced stability of nitrogen-doped carbon-supported palladium catalyst for oxidative carbonylation of phenol显示文摘Enhancing the stability of supported noble metal catalysts emerges is a major challenge in both science and industry.Herein,a heterogeneous Pd catalyst(Pd/NCF)was prepared by supporting Pd ultrafine metal nanoparticles(NPs)on nitrogen-doped carbon;synthesized by using F127 as a stabilizer,as well as chitosan as a carbon and nitrogen source.The Pd/NCF catalyst was efficient and recyclable for oxidative carbonylation of phenol to diphenyl carbonate,exhibiting higher stability than Pd/NC prepared without F127 addition.The hydrogen bond between chitosan(CTS)and F127 was enhanced by F127,which anchored the N in the free amino group,increasing the N content of the carbon material and ensuring that the support could provide sufficient N sites for the deposition of Pd NPs.This process helped to improve metal dispersion.The increased metal-support interaction,which limits the leaching and coarsening of Pd NPs,improves the stability of the Pd/NCF catalyst.Furthermore,density functional theory calculations indicated that pyridine N stabilized the Pd^(2+)species,significantly inhibiting the loss of Pd^(2+)in Pd/NCF during the reaction process.This work provides a promising avenue towards enhancing the stability of nitrogen-doped carbon-supported metal catalysts. | Xiaojing Liu Ruohan Zhao Hao Zhao Zhimiao Wang Fang Li Wei Xue Yanji Wang | 2024 | Chinese Journal of Chemical Engineering2024，65，1： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员