| 1 | Structure,morphology,and microwave dielectric properties of SmAlO_(3) synthesized by stearic acid route显示文摘A rapid and facile approach was developed for the synthesis of ultrafine SmAlO_(3) powders through the combustion of stearic acid precursors.The obtained products were characterized by typical techniques including X-ray diffraction(XRD),Fourier Transform Infrared(FT-IR),thermogravimetric and differential thermal analysis(TG-DTA),scanning electron microscopy(SEM),and transmission electron microscopy(TEM)to analyze the phase composition and microstructure.The dielectric characteristics of SmAlO_(3) microwave ceramics,using the as-obtained products as original materials,were also studied.Compared with the conventional solid-state reaction method,the synthesis temperature was dramatically reduced to 750℃.The large-size sheet structure was composed of a number of micro/nano-scale crystallites,which were mostly irregular in shape due to the mutual growth and overlapping shapes of adjacent grains.The SmAlO_(3) ceramics with high density and uniform microstructure were obtained after sintering at 1500℃ for 4 h due to the favorable sintering activity of the as-synthesized powders.In addition,desired dielectric properties at microwave frequencies(dielectric constant ε_(r)=20.22,quality factor Q·f=74110 GHz,and a temperature coefficient of resonant frequency τ_(f)=-74.6 ppm/℃)were achieved. | Jiamao LI Chuimin ZHANG Hui LIU Tai QIU Chuangang FAN | 2020 | Journal of Advanced Ceramics2020，9，5： | 3 |
| 2 | Utilization of Low-Alkalinity Cementitious Materials in Cemented Paste Backfill of Gold Mine Tailings显示文摘The purpose of this paper was to explore the possility of using low alkalinity cementitious materials as binders,in which ground blast furnace slag and fly ash acted as a partial replacement of ordinary Portland cement,and CaSO_(4),Na_(2)SO_(4),and CaO were used as a sulfate activator and alkali activated additives,to solidify gold mine tail-ings for preparation of a green,inexpensive cemented paste backill(CPB).For this target,the effects of cement/tailings ratio,superplasticizer dosage,solid content,tailings fineness on the mechanical properties of the CPB were inves tigated.Additionally,the hydration mechanism of the CPB was analyzed based on X-ray diffraction and scanning electron microscopy results.The results showed that the fuidity of the CPB slurry could be improved by adding polycarboxylic acid superplasticizer.The unconfined compressive strength(UCS)of the CPB specimens was increased with the increase of cement/tailings ratio and solid content.Under the same experi-mental conditions,the 28 d UCS of the CPB specimens was 3.8-4.9 times higher than that of ordinary Portland cement.The softening coefficient of the CPB specimens was increased with the increasing cement/tailings ratio,ranging from 0.83 to 0.92.The shrinkage rate of the CPB specimens was decreased from 0.70%to 0.54%with the increase of cement/tailings ratio from 1:12 to 1:4 The UCS of the full tailings CPB was the highest,followed by the fine tailings CPB specimens,and the UCS of the coarse tailings CPB specimens was the lowest.The low alka-linity binder was proved to be a promising material to improve the engineering performances of the CPB.The optimal mixing ratio is 1:6 cement/tailings ratio,0.15 wt% superplastizer dosage,and 70 wt%solid content.Pre-pared by this mixing ratio,the UCS values of the CPB after 3,7,and 28 d curing ages reached 1.85,5.87,and 9.16 MPa,respectively,which were suitable as CPB for the Zhaoyuan gold mine in terms of strength requirements. | Jiamao Li Chuimin Zhang Lin Li Chuangang Fan Zhaofang He Yuandi Qian | 2022 | Journal of Renewable Materials2022，10，12： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员