|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Characteristics of two types of C-S-H gel in hardened complex binder pastes blended with slag显示文摘The characteristics of C-S-H gel in hardened Portland cement pastes and complex binder pastes with ground granulated blast furnace slag were investigated with nanoindentation. The composition of C-S-H gel was analysed with SEM-EDS. The obtained results showed that the volume fraction of LD C-S-H gradually reduced and the volume fraction of HD C-S-H increased with the prolongation of hydration age. Most of the C-S-H gel produced at later age was HD C-S-H. The volume fraction of HD C-S-H increased as the fraction of slag in complex binder pastes increased, suggesting that HD C-S-H was mainly in the hydration products of slag. The chemichal compositions of the two types of C-S-H gel were simlar, meaning that formation and transformation of the two types of C-S-H gel were not affected by their Ca/Si ratio. | LIU RengGuang HAN FangHui YAN PeiYu | 2013 | Science China(Technological Sciences)2013，56，6： | 8 |
| 2 | Accuracy of triage strategies for human papillomavirus DNA-positive women in low-resource settings:A cross-sectional study in China显示文摘Objective: Care HPV is a human papillomavirus(HPV) DNA test for low-resource settings(LRS).This study assesses optimum triage strategies for care HPV-positive women in LRS.Methods: A total of 2,530 Chinese women were concurrently screened for cervical cancer with visual inspection with acetic acid(VIA),liquid-based cytology and HPV testing by physician-and self-collected care HPV,and physician-collected Hybrid Capture 2(HC2).Screen-positive women were referred to colposcopy with biopsy and endocervical curettage as necessary.HPV-positivity was defined as ≥1.0 relative light units/cutoff(RLU/CO) for both care HPV and HC2.Primary physician-HC2,physician-care HPV and self-care HPV and in sequential screening with cytology,VIA,or increased HPV test-positivity performance,stratified by age,were assessed for cervical intraepithelial neoplasia(CIN) grade 2/3 or worse(CIN2/3+) detection.Results: The sensitivities and specificities of primary HPV testing for CIN2+ were: 83.8%,88.1% for physiciancare HPV; 72.1%,88.2% for self-care HPV; and 97.1%,86.0% for HC2.Physician-care HPV test-positive women with VIA triage had a sensitivity of 30.9% for CIN2+ versus 80.9% with cytology triage.Self-care HPV testpositive women with VIA triage was 26.5% versus 66.2% with cytology triage.The sensitivity of HC2 test-positive women with VIA triage was 38.2% versus 92.6% with cytology triage.The sensitivity of physician-care HPV testing for CIN2+ decreased from 83.8% at ≥1.0 RLU/CO to 72.1% at ≥10.00 RLU/CO,while the sensitivity of selfcare HPV testing decreased from 72.1% at ≥1.0 RLU/CO to 32.4% at ≥10.00 RLU/CO; similar trends were seen with age-stratification.Conclusions: VIA and cytology triage improved specificity for CIN2/3 than no triage.Sensitivity with VIA triage was unsuitable for a mass-screening program.VIA provider training might improve this strategy.Cytology triage could be feasible where a high-quality cytology program exists.Triage of HPV test-positive women by increased test positivity cutoff adds another LRS triage option. | Margaret Wang Shangying Hu Shuang Zha o Wenhua Zhang Qinjing Pan Xun Zhang FengChen Jinxiu Han Junfei Ma Jennifer S.Smith Youlin Qiao Caihong Zhou Fanghui Zhao | 2017 | Chinese Journal of Cancer Research2017，29，6： | 6 |
| 3 | Hydration heat evolution and kinetics of blended cement containing steel slag at different temperatures 显示文摘 | HAN Fanghui ZHANG Zengqi WANG Dongmin | 2015 | Thermochimica Acta2015，605，： | 1 |
| 4 | Hydration kinetics of composite binder containing slag at different temperatures 显示文摘 | HAN Fanghui ZHANG Zengqi WANG Dongmin | 2015 | Journal of Thermal Analysis and Calorimetry2015，121，2： | 1 |
| 5 | Polybenzimidazole containing ether units as electrolyte for high temperature proton exchange membrane fuel cells显示文摘 | Yu Kang Jing Zou Zhaonan Sun Fanghui Wang Hong Zhu Kefei Han Wensheng Yang Huaihe Song Qinghan Meng | 2013 | International Journal of Hydrogen Energy2013，，15： | 1 |
| 6 | Experimental studies on the utilization of steel slag in the steam-cured concrete显示文摘The possibility of applying steel slag as mineraladmixture in steam-cured concrete was investigated. Thecompressive strength, chloride permeability, carbonationdepth and drying shrinkage of concrete and the microstructurecharacteristics of hardened paste were studied. Results showthat the steam-cured concrete containing steel slag at a highwater-to-binder ratio has low compressive strength, coarsepore structure, moderate permeability, large carbonation depthand great drying shrinkage. The negative effects of steel slagon the mechanical and durability performance of steam-curedconcrete become smaller at a low water-to-binder ratio or byadding ultrafine ground granulated blast furnace slag(UGGBS). The later-age hydration of cement is significantlypromoted by adding steel slag. The pozzolanic reaction andmicro-filler effect of UGGBS result in dense structure, whichmakes great contribution to the strength development anddurability performance of steam-cured concrete. These effectsof steel slag and UGGBS are significant at a low water tobinder ratio. The steam-cured concrete containing steel slag-UGGBS blended mineral admixture at a low water-to-binderratio has the best performance with high compressive strength,fine pore structure and good durability. | Han Fanghui Liu Juanhong He Xuejiang Song Shaomin | 2017 | Journal of Southeast University(English Edition)2017，33，3： | 1 |
| 7 | Effects of inter-layer remelting frequency on the microstructure evolution and mechanical properties of equimolar CoCrFeNiMn high entropy alloys during in-situ powder-bed arc additive manufacturing(PBAAM)process显示文摘An equiatomic CoCrFeNiMn High Entropy Alloy(HEA)was in-situ deposited by the powder-bed arc ad-ditive manufacturing(PBAAM)process for the first time.Comparative research was conducted on the evolution of phase,crystallographic orientation,dislocation morphology,precipitation,and mechanical performance with the accumulation of inter-layer remelting times.The experimental outcomes mani-fested that the PBAAMed CoCrFeNiMn HEA consists of a stable solid-solution FCC structure,with de-creased lattice parameter but slightly increased(full width at half maximum)FWHM as the accumulation of the inter-layer remelting.The{001}<100>cube texture with a weakened texture intensity was de-tected with an increment of inter-layer remelting frequency from once to 5 times,yet it was transformed into{011}<100>Goss texture with a further increase to 7 times.Additionally,the mean grain diameter distinctly decreased,while the volume fraction of(low angle grain boundaries)LAGBs and dislocation density remarkably added up as the accumulated inter-layer remelts.Predominant cellular substructure generated in all process conditions and could be easily differentiated by elemental segregation.Both theσand M 23 C 6 Cr-rich precipitates in nano-scale and submicron MnS precipitate were detected on the grain boundaries of the PBAAMed deposited components,with a rather sparse distribution.Speaking of mechanical performance,the YS,UTS,and hardening rate are generally increased while the UE is grad-ually decreased as increased inter-layer remelting times.The studied PBAAMed CoCrFeNiMn HEA pos-sesses comparable mechanical performances with the counterparts of laser-deposited and as-cast ones.The strengthening mechanisms of the studied material are predominantly the grain boundary strength-ening and dislocation strengthening.This investigation would be a valuable resource in the research field of fabricating HEA alloys with acceptable microstructure and properties using the PBAAM method. | Jun Wang Yao Lu Fanghui Jia Wenzhen Xia Fei Lin Jian Han Ruichao Wang Zengxi Pan Huijun Li Zhengyi Jiang | 2022 | Journal of Materials Science & Technology2022，，18： | 0 |
| 8 | Novel water-based nanolubricant with superior tribological performance in hot steel rolling显示文摘Novel water-based nanolubricants using TiO2 nanoparticles(NPs)were synthesised by adding sodium dodecyl benzene sulfonate(SDBS)and glycerol,which exhibited excellent dispersion stability and wettability.The tribological performance of the synthesised nanolubricants was investigated using an Rtec ball-on-disk tribometer,and their application in hot steel rolling was evaluated on a 2-high Hille 100 experimental rolling mill,in comparison to those without SDBS.The water-based nanolubricant containing 4 wt%TiO2 and 0.4 wt%SDBS demonstrated superior tribological performance by decreasing coefficient of friction and ball wear up to 70.5%and 84.3%,respectively,compared to those of pure water.In addition to the lubrication effect,the suspensions also had significant effect on polishing of the work roll surface.The resultant surface improvement thus enabled the decrease in rolling force up to 8.3%under a workpiece reduction of 30%at a rolling temperature of 850◦C.The lubrication mechanisms were primarily ascribed to the formation of lubricating film and ball-bearing effect of the TiO2 NPs. | Hui Wu Fanghui Jia Zhou Li Fei Lin Mingshuai Huo Shuiquan Huang Sepidar Sayyar Sihai Jiao Han Huang Zhengyi Jiang | 2020 | International Journal of Extreme Manufacturing2020，2，2： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员