2篇
您的检索式：作者名="Ronghui CHENG"
|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Development of Light Cycle Oil(LCO) Hydrocracking Technology over a Commercial W-Ni Based Catalyst显示文摘Because of its high density and low cetane number, the light cycle oil(LCO) containing heavy aromatics(60%—80%) can hardly be transformed through the conventional hydro-upgrading technology. In this report, a novel LCO hydrocracking technology(FD2G) was proposed for the utilization of LCO to manufacture high value-added products. Through the ingenious combination of hydroprocessing catalyst and the hydrocracking process, the high octane gasoline and the ultra-low sulfur diesel(ULSD) blendstocks were produced simultaneously. The influence of catalyst type, reaction temperature, pressure, respectively, on the research octane number(RON) of produced gasoline was studied in a fixed bed hydrogenation reactor. It indicated that high reaction temperature and medium pressure would favor the production of highoctane gasoline through the conversion of bi-aromatic and tri-aromatic hydrocarbons. The typical results of FD2 G technology on commercial units showed that it could produce clean diesel with a sulfur content of less than 10 μg/g and clean gasoline with a research octane number(RON) of up to 92. It would be contributed to the achievement of the maximum profit of a refinery, the FD2 G technology could provide a higher economic efficiency than the other diesel quality upgrading technology under the current gasoline and diesel price system. | Peng Chong Yang Xuejing Fang Xiangchen Huang Xinlu Cheng Zhenmin Zeng Ronghui Guo Rong | 2015 | China Petroleum Processing & Petrochemical Technology2015，17，4： | 9 |
| 2 | Designing method of acceleration and deceleration control schedule for variable cycle engine显示文摘Studies show that different geometries of a Variable Cycle Engine(VCE)can be adjusted during the transient stage of the engine operation to improve the engine performance.However,this improvement increases the complexity of the acceleration and deceleration control schedule.In order to resolve this problem,the Transient-state Reverse Method(TRM)is established in the present study based on the Steady-state Reverse Method(SRM)and the Virtual Power Extraction Method(VPEM).The state factors in the component-based engine performance models are replaced by variable geometry parameters to establish the TRM for a double bypass VCE.Obtained results are compared with the conventional component-based model from different aspects,including the accuracy and the convergence rate.The TRM is then employed to optimize the control schedule of a VCE.Obtained results show that the accuracy and the convergence rate of the proposed method are consistent with that of the conventional model.On the other hand,it is found that the new-model-optimized control schedules reduce the acceleration and deceleration time by 45%and 54%,respectively.Meanwhile,the surge margin of compressors,fuel–air ratio and the turbine inlet temperature maintained are within the acceptable criteria.It is concluded that the proposed TRM is a powerful method to design the acceleration and deceleration control schedule of the VCE. | Linyuan JIA Yuchun CHEN Ronghui CHENG Tian TAN Reran SONG | 2021 | Chinese Journal of Aeronautics2021，34，5： | 5 |
您所在的机构暂未开通此部分的功能，请联系管理员